Thursday, November 21, 2013

Camry Problems

Toyota Camry Check the oxygen sensor telegram harness On two the 4 cylinder and V6 engine the EFI fuse supplies share to the EFI pass along and then unconnecteds and goes to the give the axe crack computer without splitting to index number anything else. The wire is blackness/White in color, draw nearlywhere this wire is briefing to ground. upshot Check the distributor wiring Toyota doesnt release this information overly thats non the problem, in most cases the EFI fuse blows because there is a little to ground in the red/white wire that supplies suck out to the injectors and the o2 sensors as well as a clutch of separate(a) components. Open the support connector under the hood and bind the B+ final to see if its buncoed to ground, do this with the battery split using an ohm meter surrounded by the B+ terminal and be ground. Many Toyota owners have a problem with the electronic fuel injection (EFI) fuse blowing repeatedly. Here are some things to kerb: 1) The wires around the EGR tube for melting or fraying. 2) The wires near the EGR void switching valve (VSV) located under the intake manifold. 3) Wires squandered between the intake manifold and the cylinder head. 4) Wires pinched anywhere along the valve cover. 5) Check injector wiring for any pinched locations. 6) turn tail an group A test on the fuel pump.
Order your essay at Orderessay and get a 100% original and high-quality custom paper within the required time frame.
Toyota restitute - EFI fuse keeps blowing 1993 toyota camry with Ign swith on beneficial: Ted Ritter - 9/10/2009 research QUESTION: Where can I take a go on the wire diagram for the inside of a engine divorce module for a 1993 toyota camry I have a unequal on the EFI fuse ANSWER: Toyota doesn t release this information as well thats n! on the problem, in most cases the EFI fuse blows because there is a in short to ground in the red/white wire that supplies ability to the injectors and the o2 sensors as well as a lot of early(a) components. Open the punctuate connector under the hood and check the B+ terminal to see if its shorted to ground, do this with the battery scattered using an ohm meter between the...If you want to get a full essay, order it on our website: OrderEssay.net

If you want to get a full information about our service, visit our page: write my essay

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.